Author Topic: Where to get a PU scope and mount?  (Read 1842 times)

0 Members and 1 Guest are viewing this topic.

Offline Hylander

  • Trade Count: (0)
  • Newber
  • *
  • Posts: 22
Where to get a PU scope and mount?
« on: July 30, 2023, 01:21:38 AM »
I thinking of scoping an SKS and possibly using a PU setup.
Where to look for one, Not firefield.

Offline BMont

  • Trade Count: (0)
  • Marksman
  • *
  • Posts: 361
Re: Where to get a PU scope and mount?
« Reply #1 on: August 02, 2023, 03:26:56 PM »
I think you may be referring to the ON-2 Scope and Mount maybe for a yugo sniper?  Those are cammed correctly for the 7.62 round. 

Online Boris Badinov

  • BATTLEFIELD COMMISSION
  • Trade Count: (0)
  • Sharp-Shooter
  • *
  • Posts: 1292
Re: Where to get a PU scope and mount?
« Reply #2 on: August 02, 2023, 05:27:39 PM »
Accumounts makes a PU replica mount and scope specifically for the SKS:


$199 for the mount

$499 for the mount and scope (all steel)

https://accumounts.com/sks.html

Offline 1mlt

  • SKS-FILES CONTRIBUTOR
  • Trade Count: (+1)
  • Marksman
  • *
  • Posts: 721
Re: Where to get a PU scope and mount?
« Reply #3 on: August 02, 2023, 06:54:16 PM »
You want to scope a SKS wit RTZ
 here's how"Remove the dust receiver cover.
Mount your choice of rails by:
Draw (scribe) a center line on the cover.
Place the rail and mark your holes to be drilled.
Drill correct size hole to be tapped.
Tap the holes to fit the button head screws you choose.
Replace the rail and screw in the mounting screws. Lock tight in place.
Grind the screws off from the bottom side so they are flush with the curve of the cover. Needed so the bolt won't jam on them.

Remove the take down pin.
Replace the dust receiver cover. MUST be on for the tap threads to line up properly.
Tap (do not drill the hole) a 1/4-20 (or finer if you desire) hole all the way across and out the other side.
Use a grade 8, 1/4-20 x 1 3/4"L button head. MUST go all the way through and out the left side to anchor the cover.
Screw in the button head. Best if done right to left. Looks better in my opinion.
Cut to length, meaning flush with the receiver, cold blue and you are done.

Now you have a LOW mount, that will return to zero, every time you R/R it to clean your rifle.
Done this more than once, SO HAVE OTHERS HERE.
Happy Shooting
Marcus
There is but one language in the USA, English.
Teddy R.

Offline Hylander

  • Trade Count: (0)
  • Newber
  • *
  • Posts: 22
Re: Where to get a PU scope and mount?
« Reply #4 on: August 06, 2023, 12:01:10 AM »
Picking up an Accumount PU set from a friend  :)

Also I have an extra dust cover, so I  am going mount a rail to it from a S&W 686.
That will be for different SKS